Visit our community sponsor
I had FPM Metal make a dash for me. I sent them a DXF file of what I wanted and I couldn’t be happier with it. Mine is engine turned but a wouldCHOTIS BILL Today, 03:29 PM
FFR does not, and will not supply you a blank dash (I know, I tried). Other vendors do. I, just like John Dol, plan to go the difficult route and go withCarlos C Today, 01:05 PM
Here is a link to Speedway Motors where the block came from. http://www.speedwaymotors.com/P-Ayr-...lock,7447.html TheyCHOTIS BILL Today, 08:01 AM
Looking Good!wallace18 Yesterday, 03:55 PM
Finished mounting all the exterior parts prior to paint. This has definitely been the most trying part of the build. Just when you think you are doneTimb 09-21-2014, 06:58 PM
I did this cause I wanted to add a shroud to the FFR fan cause the temp was slowly rising when sitting still.
It was about 85deg outside without
....I did the same....file it away. Looks nice though.
Would have done this from the get go if I had seen it before my build.
Nice setup. I will file this away in case the FFR one failsTimb 09-19-2014, 10:07 AM
I installed my new shroud and fan's today and man it fits perfect. I only had to drill 2 new holes in the top lip of the rad, the bottom holes lined up.HCP 65 COUPE 09-18-2014, 06:21 PM