Visit our community sponsor
Thanks:
20
Likes:
104
-
Senior Member
So it turns out I'm terrible at maintaining a build thread, its been over a month! I usually browse the forum on my iPhone, and never break out the laptop to post pics. Anyway...
Plugged up the steering rack holes, haven't seen it done quite this way yet.
Grabbed a few bolts from the hardware store, had to cut the heads off to fit them in. Slotted them so I could tighten with a screwdriver. The other two were subframe bolts I think. Couldn't find my locktite so I put some JB on the threads.
Then I cut them flush.
More updates tomorrow, finally got my oven wired in the garage so its time to start powder coating.
Adam _____ Instagram @PopesProjects____
YouTube Channel
818 SRX - #91
Arrived 01/02/2014
First Start 10/31/2016
First Drive 05/22/2017
Registered 10/25/2019 BRAP818
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Visit our community sponsor