Thanks Mike. That is good to hear. It wasn't touching so I moved past it and think it will be fine. A couple other fitment issues I faced were that the quick jack holes in the front of the chassis seem too high to correctly fit the body. I couldn't get the sides to tuck under the frame without lowering the nose about 5/8". This also corrected some alignment issues I was having with the hood hinges. I ended up drilling new holes to mount the quick jacks and everything seems to work. I needed to space the passenger side hinge back about a quarter inch so that the hinge would clear the body when open. I also needed to releave the body where the lower portion of the hinge swings out on both sides to get the doors to fully open. I primed the body earlier this week and will be sanding this weekend.
Lars